GPIB to USB converter Using PIC

PIC-plot now goes to USB! A perfect low cost solution to quickly get screen plots of your GPIB instrument on your laptop PC without complex software. It emulates the HP7470A operation on the GPIB side, and outputs the HP-GL data at the USB port to be read and stored on the PC by any capturing software. GPIB addresses and other set-and-forget parameters can be configured by a simple Setup menu, then no Dip-switches are used. Power is taken from the USB port to simplify cabling and get rid of a DC adaptor.

The operation of this interface is not just limited to digital plotter emulation: any data intended to be received by a GPIB Device (addressable or listener only) can be captured from the instrument and brought out to the USB port, including raw measurement arrays or rasterized data for a graphic printer. It is based on a PIC16F628 microcontroller and an FT232R chip. PCB size is just 57x64mm.

[source]

USB Audio Digital to Analog Converter

I want to build high quality preamplifier with built-in DAC from SPDIF or USB for my power amplifier Leachamp. I tried to design DAC from USB with this circuit on one-sided PCB and I was successful.

Schematics is from datasheet of PCM2902. Circuit includes DAC and ADC, SPDIF output and input and HID part with 3 buttons for MUTE, VOL+ and VOL-. I used only DAC part. Other parts are not used. For high quality playback is needed to use external low-drop voltage stabiliser for DAC part. I used LP2951CM which was available at local store. Output voltage is set to about 3.7V with two resistors. Circuit board is designed regarding to good ground placement and separating of analog and digital ground. These ground are connected in one point at USB connector.

[source]

Infrared Thermometer Module

If you want to build non Contact Thermometer, you can try to use MLX90614. It will reduce your electronic project complexity. Outputs of this module is continuous data flow with an active alarm running in the background, 16-bit digital temperature output data that ranging from -70 °C to 380 °C and Serial data (Auto-baud detection (2400, 4800, 9600, 19.2K, 38.4K)) for microcontroller-to-MLX90614 communications.

tags: Electonic Module, Infrared Thermometer (src)